Several steps to use y-type filter
The y-type filter is shaped like a slingshot. There are two ports on the upper end, which are devices for removing small particles in the liquid. They are used in fan ducts, water ducts and oil ducts. It can protect the normal use of valves and equipment. The working process is that when the liquid enters the Y-type filter through the main pipe, the fine particles will be blocked by the filter mesh, and the clean fluid will pass through the filter mesh and be discharged from the filter outlet.
There are several steps to pay attention to when using the y-type filter. First, when installing, the water flow direction of the system must be the same as the arrow on the valve, either horizontally or vertically. Second, after installing the filter screen on the Y-type filter, see if there is any water leakage. If water leakage occurs, the gasket may be damaged and you can replace it. Third, it is necessary to check whether there are too many impurities in the Y-type filter on time. This method can be used to install pressure gauges at both ends of the filter. When the pressure readings at the two ends differ greatly, it indicates that there is already A lot of impurities can be cleaned. Fourth, the filter should be installed and used together with the shut-off valve, and shut-off valves should be installed upstream and downstream of the filter, so that it is convenient to operate during maintenance.
When servicing the Y-type filter, you should also pay attention to frequently cleaning the filter, which is easy to breed bacteria and contaminate the liquid in the pipeline. I would like to remind everyone that in order to protect the equipment to work normally for a long time and for a long time, during daily use and maintenance, it is necessary to protect the fittings on the equipment pipeline from wear and blockage.